You can tag with thread only by 2 x lever actions.
*Easier tagging is guaranteed with double loop.
*Helps merchandizes shown up with sophiscated thread.
*Stress free and higher tagging quality.
*More than 50% labour cost save is possible.
*No electricity required and Eco-friendly
*Made in Japan
1. Release the safety lock before use. Pull the lever once, and the needle comes out.
2. Put the article and tag via hole onto the needle.
3. By holding the article and tag slightly toward foreside of gun, and pull lever once again.
4. The tag is firmly tied with the article with double loop thread.
Two loop sizes are available for TT6-H.
*Many colour of genuin thread are available for TT6-H
New TAGTACH, TT7-H is for thinner thread, with 1 x loop tagging.
*Complete tagging only 2 x lever actions.
*More versality for tagging work.
*Stress free and higher tagging quality.
*More than 50% labour cost save is possible.
*No electricity required and Eco-Friendly.
*Made in Japan
*Firm and speedy tagging work even for RFID tags.
1. Pull lever once, and then, pipe comes out.
2. Put tag and article through pipe.
3. Hold tag and article, and pull lever untill it stops.
4. Remove tag and article from TAGTACH, TT7-H. Tag is firmly tied with single loop thread.
* Bobbin for thinner nylon, gold/silver, and for TT6-H can be used with TT7-H.
TAGTACH is only one product as Tag Stringer in the world.
TAGTACH is widely used in many places, as Jewellery shops, factory, and versatile tagging works are possible.
Made in Japan
